SN74LVC1G3157DSFR
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Lifecycle Status | ACTIVE (Last Updated: 5 days ago) |
| Contact Plating | Gold |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 6-XFDFN |
| Number of Pins | 6 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| JESD-609 Code | e4 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 6 |
| ECCN Code | EAR99 |
| Resistance | 15Ohm |
| Subcategory | Multiplexers or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 2.3V |
| Terminal Pitch | 0.35mm |
| Base Part Number | 74LVC1G3157 |
| Pin Count | 6 |
| Number of Outputs | 2 |
| Polarity | Non-Inverting |
| Number of Channels | 1 |
| Number of Circuits | 1 |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 1.65V |
| Operating Supply Current | 1μA |
| Nominal Supply Current | 1μA |
| Max Supply Current | 10μA |
| Propagation Delay | 300 ps |
| Turn On Delay Time | 5.7 ns |
| Supply Type | Single |
| Bandwidth | 340MHz |
| Turn-Off Delay Time | 3.8 ns |
| -3db Bandwidth | 340MHz |
| On-State Resistance (Max) | 15Ohm |
| High Level Output Current | 128mA |
| Low Level Output Current | 128mA |
| Multiplexer/Demultiplexer Circuit | 2:1 |
| Off-state Isolation-Nom | 57 dB |
| Channel Capacitance (CS(off), CD(off)) | 5.2pF |
| On-state Resistance Match-Nom | 0.1Ohm |
| Switch Circuit | SPDT |
| Switch Time (Ton, Toff) (Max) | 5.7ns, 3.8ns |
| Charge Injection | 7pC |
| Channel-to-Channel Matching (ΔRon) | 100m Ω |
| Crosstalk | -54dB @ 10MHz |
| Switching | BREAK-BEFORE-MAKE |
| Voltage - Supply, Single (V+) | 1.65V~5.5V |
| Normal Position | NC |
| Height | 400μm |
| Length | 1mm |
| Width | 1mm |
| Thickness | 350μm |
| Radiation Hardening | No |
| REACH SVHC | No SVHC |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
SN74LVC1G3157DSFR Overview
The electronic component is convenient to ship overseas because it is packed in a 6-XFDFN. The advanced packaging method Tape & Reel (TR) provides high reliability. In Surface Mount, this analog switch is mounted. 2:1 is the number of circuits in the multiplexer and demultiplexer. Temperatures around -40°C~85°C TA are extended for operation. In total, 6 terminations have occurred. This electronic part offers high-quality output due to its 1 channels. An 2.3V voltage supply should allow the electrical part to be turned on and run. As part of the design of the 6 series, this electronic part has been incorporated into the system. SPDT switching circuits are used in these analog switch ics. There are 1 circuits in this multiplexer. Try searching for the analog switch ic with 74LVC1G3157 if you are looking for variants. It has an internal resistance of 15Ohm. Datasheets for 6 pin functions are available upon request. The analog multiplexer shown here is a typical Multiplexers or Switches. Users shouldn't supply more than 5.5V voltage to the switch device. An effective Single supply digital multiplexer. It is recommended to use 1.65V as the lowest voltage for the electrical part. 1μA current would be enough for this multiplexer to operate. A voltage of 1.65V~5.5V is required to drain this analog switch from a single voltage supply. Put voltage above 10μA on the multiplexer to cause damage. It is possible to transfer data over a 340MHz-bandwidth. An output of 2 is provided by the digital multiplexer.
SN74LVC1G3157DSFR Features
1 Channels
Switch Circuit: SPDT
1μA Supply Current
-3db Bandwidth: 340MHz
Bandwidth: 340MHz
SN74LVC1G3157DSFR Applications
There are a lot of Texas Instruments SN74LVC1G3157DSFR Analog Switches & Multiplexers ICs applications.
- Microprocessor Controlled Analog Systems
- SDH/SONET multiplexers
- New designs requiring multiplexer functions
- Multiplexers
- T1/E1 Terminals
- E1 Network Equipment
- Public switching systems
- Channel Banks
- Automotive applications
- SDH
