SR2HARU
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Lifecycle Status | ACTIVE (Last Updated: 7 months ago) |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 6-UFDFN |
| Number of Pins | 6 |
| Weight | 21.092045mg |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Cut Tape (CT) |
| Series | Smart Reset™ |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 6 |
| ECCN Code | EAR99 |
| Type | Reset Timer |
| Terminal Position | DUAL |
| Number of Functions | 1 |
| Supply Voltage | 3V |
| Terminal Pitch | 0.4mm |
| Base Part Number | SR2 |
| Output | Open Drain or Open Collector |
| Number of Channels | 1 |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 1.65V |
| Nominal Supply Current | 3μA |
| Adjustable Threshold | NO |
| Watchdog Timer | No |
| Reset | Active Low |
| Number of Voltages Monitored | 1 |
| Reset Timeout | Adjustable/Selectable |
| Min Reset Threshold Voltage | 300mV |
| Max Reset Threshold Voltage | 5.5V |
| Height | 550μm |
| Length | 1.6mm |
| Width | 1.3mm |
| REACH SVHC | No SVHC |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
SR2HARU Overview
As far as the mounting terminals of this voltage supervisor are concerned, it has 6 in total. Power management is packaged in a Cut Tape (CT) way. Please refer to this PMIC for 1 functions. This power managment ic consists of 1 channels, each of which can be used independently. IC management is packaged as a 6-UFDFN package. As with other Reset Timer products, this IC management also offers a wide range of benefits. In a 3V supply voltage, the power management conducts. A supply voltage of 1 is used to conduct the PMIC chip. The mount is attached to Surface Mount. This power management system has 6 pins. Supply voltage (Vsup) should be at least 1.65V for this power management. The maximum supply voltage (Vsup) in this PMIC should not exceed 5.5V volts. In this case, Surface Mount is the recommended mounting type. This range of temperature should be set for the supervisors: -40°C~85°C TA. There is an output voltage of Open Drain or Open Collector from this supervisor when it is operating. A similar IC managements number of the manufacturer can always be found by using SR2, the base power ics number. The IC power comes from the well-known Smart Reset? series.
SR2HARU Features
Reset Timer type
Minimum supply voltage of 1.65V
SR2HARU Applications
There are a lot of STMicroelectronics SR2HARU Voltage Supervisors applications.
- Telecommunications equipment
- Medical-specific isolation transformer
- Analog circuit
- Consumer electronics
- Kitchen appliances
- Leakage current detection
- Power communication system
- Computer applications
- Detection of phase loss
- Personal computers
