ST2051BDR
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 8-SOIC (0.154, 3.90mm Width) |
| Number of Pins | 8 |
| Operating Temperature | -40°C~125°C TJ |
| Packaging | Tape & Reel (TR) |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 3 (168 Hours) |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Base Part Number | ST2051 |
| Pin Count | 8 |
| Number of Outputs | 1 |
| Qualification Status | Not Qualified |
| Output Type | N-Channel |
| Supply Voltage-Min (Vsup) | 2.7V |
| Number of Channels | 1 |
| Interface | On/Off |
| Analog IC - Other Type | POWER SUPPLY SUPPORT CIRCUIT |
| Current - Output (Max) | 500mA |
| Output Configuration | High Side |
| Output Current | 0A |
| Voltage - Supply (Vcc/Vdd) | Not Required |
| Adjustable Threshold | NO |
| Input Type | Non-Inverting |
| Switch Type | General Purpose |
| Nominal Input Voltage | 5V |
| Ratio - Input:Output | 1:1 |
| Voltage - Load | 2.7V~5.5V |
| Fault Protection | Current Limiting (Fixed), Over Temperature, UVLO |
| Rds On (Typ) | 80m Ω |
| Length | 4.9mm |
| Width | 3.9mm |
| RoHS Status | ROHS3 Compliant |
ST2051BDR Overview
Tape & Reel (TR) is the way it's packaged.Package 8-SOIC (0.154, 3.90mm Width) contains it.The lighting driver has the mounting type Surface Mount.It owns General Purpose switch type.Keeping the temperature at -40°C~125°C TJ ensures reliable operation.It is possible to use 1 outputs in the lighting driver.Operation is based on a supply voltage of Not Required.A maximum voltage of N-Channel volts is available from the output of this LED driver.It is part of the ST2051 family of LED drivers.It contains 8 terminations.In order to operate, the 8 pins are used.The LED driver has 1 functions.The maximum output of the LED driving board is 500mAV.High efficiency is possible when the supply voltage is set to 5V.The lighting driver is mounted in the way of Surface Mount.A total of 8 pins are present on it.The output current is set to 0A in this case.In order to operate normally, the supply voltage (Vsup) must remain above 2.7V.This gadget uses an analog IC, which is POWER SUPPLY SUPPORT CIRCUIT in this case.We currently have 1 channels available.
ST2051BDR Features
Supplied from 5V
1 channels
ST2051BDR Applications
There are a lot of STMicroelectronics ST2051BDR Power Switches ICs applications.
- Portable GPS Device
- Smartphone and PDA
- Wireless/Networking Cards
- Storage (HDDs, SSDs)
- Storage Drives
- Set-Top Boxes
- PC Card Hot Swap
- Solid-State Drives
- Low Voltage I/O System Power
- Hot Swap
