STK672-630A-E
| Parameters | |
|---|---|
| Mount | Through Hole |
| Mounting Type | Through Hole |
| Package / Case | 19-SSIP Formed Leads |
| Number of Pins | 19 |
| Operating Temperature | 0°C~105°C TC |
| Packaging | Tape & Box (TB) |
| Published | 2009 |
| JESD-609 Code | e2 |
| Pbfree Code | yes |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 19 |
| Terminal Finish | Tin/Nickel (Sn/Ni) |
| Applications | General Purpose |
| Subcategory | Motion Control Electronics |
| Technology | Power MOSFET |
| Voltage - Supply | 4.75V~5.25V |
| Terminal Position | ZIG-ZAG |
| Supply Voltage | 5V |
| Base Part Number | STK672 |
| Function | Driver - Fully Integrated, Control and Power Stage |
| Number of Outputs | 1 |
| Supply Voltage-Max (Vsup) | 5.25V |
| Power Supplies | 524V |
| Supply Voltage-Min (Vsup) | 4.75V |
| Interface | Parallel |
| Analog IC - Other Type | STEPPER MOTOR CONTROLLER |
| Nominal Supply Current | 4.4A |
| Output Configuration | Half Bridge (2) |
| Power Dissipation | 7.3W |
| Supply Current-Max (Isup) | 8mA |
| Collector Emitter Voltage (VCEO) | 42V |
| Max Collector Current | 2.2A |
| Voltage - Load | 10V~42V |
| Switching Frequency | 45kHz |
| Motor Type - Stepper | Unipolar |
| Step Resolution | 1, 1/2 |
| Height | 14.4mm |
| Length | 29.2mm |
| Width | 4.5mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
STK672-630A-E Overview
The design contains a Tape & Box (TB)package.Drivers controllers comes in a 19-SSIP Formed Leads case.A mounting position of Through Holeis recommended for the part.In this case, it is appropriate for the component connected to General Purpose.A device with a voltage range of 4.75V~5.25V volts is available.In terms of operating temperature, it falls within the range 0°C~105°C TC.In this part, there are 19 terminations available.The voltage can applied to the load at the rate of 10V~42V.You should run this amplifier at 5V.Through Holeis its recommended mounting method.A STEPPER MOTOR CONTROLLERanalog integrated circuit is used in the device.Using the STK672part number, it is located.This device is designed with a pin count of 19.This is part of the Motion Control Electronics series.A total of 1outputs are available.
STK672-630A-E Features
Applications : General Purpose
Load voltage across the chip 10V~42V
base on STK672 number
designed with 1 outputs
STK672-630A-E Applications
There are a lot of ON Semiconductor STK672-630A-E motor drivers applications.
- Turn signals
- General lighting
- Mobile phone display backlight and key light driving
- Automotive applications
- AM radio
- PWM generators
- Charge pump circuits
- Large outdoor LED display
- Daytime running lights (DRLs)
- Commercial office
