STLA02PUR
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Lifecycle Status | ACTIVE (Last Updated: 7 months ago) |
| Contact Plating | Gold |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 6-WFDFN Exposed Pad |
| Number of Pins | 6 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| JESD-609 Code | e4 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 6 |
| ECCN Code | EAR99 |
| Type | DC DC Regulator |
| Terminal Finish | Nickel/Palladium (Ni/Pd) |
| Applications | Backlight |
| Subcategory | Display Drivers |
| Max Power Dissipation | 530mW |
| Terminal Position | DUAL |
| Supply Voltage | 3V |
| Terminal Pitch | 0.5mm |
| Frequency | 2MHz |
| Base Part Number | STLA02 |
| Number of Outputs | 1 |
| Power Supplies | 3V |
| Max Supply Voltage | 18V |
| Min Supply Voltage | 2.5V |
| Nominal Supply Current | 4mA |
| Power Dissipation | 530mW |
| Output Current | 20mA |
| Max Supply Current | 2mA |
| Voltage - Output | 27V |
| Topology | Step-Up (Boost) |
| Internal Switch(s) | Yes |
| Dimming | PWM |
| Voltage - Supply (Min) | 2.5V |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
STLA02PUR Overview
It saves board space with the 6-WFDFN Exposed Pad package. This LED driver has 1 outputs.The led light driver is mounted using Surface Mount.It is highly reliable and high-performing when it emerges as a DC DC Regulator.If the led driver ic is set to -40°C~85°C TA, it will work normally.As a result, Backlight is likely to benefit greatly.2MHz is the frequency in which it operates.6 terminations are used in its operation.The LED light driver is configured with a base of 0 pins.If the voltage supply is below 2.5V, undetermined failures may occur.The device has been mounted on the Surface Mount.The LED driver is available under the part number STLA02.An acceptable maximum value for the supply voltage is 18V.There is 27V voltage output from this device.In addition, it can also be categorized into Display Drivers based on its characteristics.A minimal supply voltage of 2.5V is required for it to achieve the highest efficiency.It is possible to obtain a high efficiency with this device when the maximum supply current is less than 2mA.20mA is the maximum amount of current that can be supplied to the load.
STLA02PUR Features
Available in the 6-WFDFN Exposed Pad package
Operating temperature of -40°C~85°C TA
Frequency of 2MHz
Supply voltage of 3V
STLA02PUR Applications
There are a lot of STMicroelectronics STLA02PUR LED Driver ICs applications.
- Flicker-free LED Lighting using R1580N
- Medical surgery lighting
- Stage and Studio lighting
- White LED Backlight for portable equipment
- Linear fluorescent
- Refrigeration lighting
- LED Lightings for Inspection Devices
- LED headlights
- Scanners and Handy Terminals
- Ultraviolet (UV) and Infrared (IR) Irradiation Devices
