banner_page

STWD100YNWWY3F

STWD100 Voltage supervisorAutomotive, AEC-Q100 Series Min 2.7V Max 5.5V


  • Manufacturer: STMicroelectronics
  • Nocochips NO: 761-STWD100YNWWY3F
  • Package: SC-74A, SOT-753
  • Datasheet: PDF
  • Stock: 261
  • Description: STWD100 Voltage supervisorAutomotive, AEC-Q100 Series Min 2.7V Max 5.5V (Kg)

Details

Tags

Parameters
Factory Lead Time 1 Week
Mount Surface Mount
Mounting Type Surface Mount
Package / Case SC-74A, SOT-753
Number of Pins 5
Weight 29.993795mg
Operating Temperature -40°C~125°C TA
Packaging Tape & Reel (TR)
Series Automotive, AEC-Q100
JESD-609 Code e4
Part Status Active
Moisture Sensitivity Level (MSL) 1 (Unlimited)
ECCN Code EAR99
Type Watchdog Circuit
Terminal Finish Nickel/Palladium/Gold (Ni/Pd/Au)
Peak Reflow Temperature (Cel) NOT SPECIFIED
Time@Peak Reflow Temperature-Max (s) NOT SPECIFIED
Base Part Number STWD100
Output Open Drain or Open Collector
Max Supply Voltage 5.5V
Min Supply Voltage 2.7V
Operating Supply Current 13μA
Reset Active Low
Reset Timeout 5.1ms Minimum
Number of Timers/Counters 1
Height 1.3mm
Length 3mm
Width 1.75mm
RoHS Status ROHS3 Compliant
Lead Free Lead Free

STWD100YNWWY3F Overview


A Tape & Reel (TR) package is used to package the power management. IC management is packaged as a SC-74A, SOT-753 package. It is a IC power that shares many benefits with other products from the Watchdog Circuit line. Specifies a reflow peak temperature of NOT SPECIFIED for the package during reflow. The power management is mounted by a Surface Mount-axis. Power managment ic pin count is 5. It is recommended that Vsup should not be less than 2.7V for this IC power. There should be no more than 5.5V volts of supply voltage (Vsup) in this power management. Power management' mounting is recommended to be done with the Surface Mount type of mounting. You should set the supervisor's temperature during -40°C~125°C TA . As this power managment ic operates, it is able to produce an output voltage of Open Drain or Open Collector. The power management's supply current is 13μA. A similar IC managements number of the manufacturer can always be found by using STWD100, the base power ics number. A PMIC from the well-known Automotive, AEC-Q100 series of products is being offered here.

STWD100YNWWY3F Features


Watchdog Circuit type
Minimum supply voltage of 2.7V
13μA operating supply current

STWD100YNWWY3F Applications


There are a lot of STMicroelectronics STWD100YNWWY3F Voltage Supervisors applications.

  • Kitchen appliances
  • WiFi router
  • Utility meter
  • Important electronics for automotive safety
  • Analog circuit
  • Transformer load monitoring equipment
  • Smart meter
  • Urban rail transit weak current power monitoring
  • Battery cars
  • Automotive permanent magnet synchronous motors

Write a review

Note: HTML is not translated!
    Bad           Good