TC1270ANTVRCTR
| Parameters | |
|---|---|
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 1V |
| Operating Supply Current | 10μA |
| Adjustable Threshold | NO |
| Quiescent Current | 7μA |
| Watchdog Timer | No |
| Reset | Active Low |
| Voltage - Threshold | 3.08V |
| Number of Voltages Monitored | 1 |
| Reset Timeout | 140ms Minimum |
| Min Reset Threshold Voltage | 2.72V |
| Max Reset Threshold Voltage | 2.82V |
| Undervoltage Threshold | 2.72V |
| Overvoltage Threshold | 2.82V |
| Length | 2.9mm |
| RoHS Status | ROHS3 Compliant |
| Factory Lead Time | 1 Week |
| Mounting Type | Surface Mount |
| Package / Case | TO-253-4, TO-253AA |
| Surface Mount | YES |
| Number of Pins | 4 |
| Operating Temperature | -40°C~125°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2011 |
| JESD-609 Code | e4 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 4 |
| ECCN Code | EAR99 |
| Type | Simple Reset/Power-On Reset |
| Terminal Finish | Nickel/Palladium/Gold (Ni/Pd/Au) |
| Subcategory | Power Management Circuits |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 3V |
| Time@Peak Reflow Temperature-Max (s) | 40 |
| Base Part Number | TC1270AN |
| Output | Open Drain or Open Collector |
| Pin Count | 4 |
| Power Supplies | 3.3V |
| Number of Channels | 1 |
TC1270ANTVRCTR Overview
As far as the mounting terminals of this voltage supervisor are concerned, it has 4 in total. A Tape & Reel (TR) package is used to package the power management. Power management is possible to find a series of 1 functions. This power managment ic consists of 1 channels, each of which can be used independently. There are TO-253-4, TO-253AA functions included in this PMIC so that you can refer to them. There are a number of benefits that this PMIC has in common with other Simple Reset/Power-On Reset manage ics. Specifies a reflow peak temperature of 260 for the package during reflow. During operation, the power ic is supplied with a voltage of 3V. In a 1 supply voltage, the PMIC chip conducts. In this case, this PMIC chip can be sub-categorized as a Power Management Circuits chip. In total, the power management has 4 pins in it. 4 pins are present on the power management system. Normally, the supply voltage (Vsup) for this PMIC should not be lower than 1V. The maximum supply voltage (Vsup) is not to exceed 5.5V volts in this IC management. Mounting type Surface Mount is recommended. The supervisors should be set to the following temperature: -40°C~125°C TA. During operation, this power management system outputs Open Drain or Open Collector. The power management's supply current is 10μA. A similar IC managements number of the manufacturer can always be found by using TC1270AN, the base power ics number. To be able to work, this power management requires 3.3V volts of power.
TC1270ANTVRCTR Features
Simple Reset/Power-On Reset type
Minimum supply voltage of 1V
10μA operating supply current
TC1270ANTVRCTR Applications
There are a lot of Microchip Technology TC1270ANTVRCTR Voltage Supervisors applications.
- Power distribution systems of infant care room
- Low voltage/high power - AI, GPU
- Consumer electronics
- Transformer load monitoring equipment
- Radio
- Leakage protection
- Medical-specific insulation monitor
- Microprocessor system
- Urban rail transit weak current power monitoring
- Refrigeration
