TC1270ASVCTTR
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | SC-74A, SOT-753 |
| Number of Pins | 5 |
| Operating Temperature | -40°C~125°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2011 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 5 |
| ECCN Code | EAR99 |
| Type | Simple Reset/Power-On Reset |
| Terminal Finish | Matte Tin (Sn) |
| Subcategory | Power Management Circuits |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 3.3V |
| Time@Peak Reflow Temperature-Max (s) | 40 |
| Base Part Number | TC1270A |
| Output | Push-Pull, Totem Pole |
| Pin Count | 5 |
| Power Supplies | 3.3V |
| Number of Channels | 1 |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 1V |
| Operating Supply Current | 10μA |
| Adjustable Threshold | NO |
| Quiescent Current | 7μA |
| Watchdog Timer | No |
| Reset | Active Low |
| Voltage - Threshold | 2.93V |
| Number of Voltages Monitored | 1 |
| Reset Timeout | 140ms Minimum |
| Min Reset Threshold Voltage | 2.88V |
| Max Reset Threshold Voltage | 2.98V |
| Undervoltage Threshold | 2.88V |
| Overvoltage Threshold | 2.98V |
| Length | 2.9mm |
| RoHS Status | ROHS3 Compliant |
TC1270ASVCTTR Overview
A total of 5 terminals are used to mount this power management. Tape & Reel (TR)-packaging is used. There are 1 functions included in this PMIC so that you can refer to them. There are 1 channels on this power managment ic that can be found in a series. In this PMIC, you can find SC-74A, SOT-753 functions for your reference. Compared to other Simple Reset/Power-On Reset products, this PMIC has a lot of benefits to offer. Specifies a reflow peak temperature of 260 for the package during reflow. In a 3.3V supply voltage, the power management conducts. IC management is possible to find a succession of 1 voltages that have been checked. Surface Mount mounts IC management. As a subcategory, this PMIC chip can be categorized as Power Management Circuits. The total number of pins on this power management is 5. 5 pins are on the supervisor. Supply voltage (Vsup) should be at least 1V for this power management. During this IC power, the maximum supply voltage (Vsup) should not exceed 5.5V volts. Power management recommends the Surface Mount mounting type. The temperature of the supervisors should be set to this range: -40°C~125°C TA. During operation, this power management system outputs Push-Pull, Totem Pole. The supply current of the power management is 10μA. A similar IC managements number of the manufacturer can always be found by using TC1270A, the base power ics number. In order to operate this power management, it requires 3.3V volts of power.
TC1270ASVCTTR Features
Simple Reset/Power-On Reset type
Minimum supply voltage of 1V
10μA operating supply current
TC1270ASVCTTR Applications
There are a lot of Microchip Technology TC1270ASVCTTR Voltage Supervisors applications.
- Dash board
- Consumer electronics
- Power distribution systems of CCU
- Automotive power systems
- FPGA design
- Utility meter
- Electronics installed in the vehicle
- emergency room
- Fire equipment power monitoring system
- Important electronics for automotive safety
