TC7652CPA
| Parameters | |
|---|---|
| Operating Supply Voltage | 8V |
| Power Supplies | +-5V |
| Number of Circuits | 1 |
| Operating Supply Current | 1mA |
| Nominal Supply Current | 3mA |
| Power Dissipation | 730mW |
| Slew Rate | 1V/μs |
| Architecture | CHOPPER-STAB |
| Amplifier Type | Zero-Drift |
| Common Mode Rejection Ratio | 120 dB |
| Current - Input Bias | 30pA |
| Voltage - Supply, Single/Dual (±) | 5V~16V ±2.5V~8V |
| Input Offset Voltage (Vos) | 5μV |
| Bandwidth | 400 kHz |
| Neg Supply Voltage-Nom (Vsup) | -5V |
| Unity Gain BW-Nom | 400 kHz |
| Voltage Gain | 150dB |
| Power Supply Rejection Ratio (PSRR) | 120dB |
| Low-Offset | YES |
| Frequency Compensation | YES |
| Supply Voltage Limit-Max | 9V |
| Voltage - Input Offset | 2mV |
| Low-Bias | YES |
| Micropower | NO |
| Max Frequency | 550Hz |
| Programmable Power | NO |
| Number of Amplifiers | 2 |
| Height | 4.06mm |
| Length | 10.16mm |
| Width | 6.6mm |
| Radiation Hardening | No |
| REACH SVHC | No SVHC |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
| Factory Lead Time | 1 Week |
| Mount | Through Hole |
| Mounting Type | Through Hole |
| Package / Case | 8-DIP (0.300, 7.62mm) |
| Number of Pins | 8 |
| Operating Temperature | 0°C~70°C |
| Packaging | Tube |
| Published | 1998 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| ECCN Code | EAR99 |
| Resistance | 1 TΩ |
| Terminal Finish | Matte Tin (Sn) |
| Subcategory | Operational Amplifier |
| Technology | CMOS |
| Terminal Position | DUAL |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Base Part Number | TC7652 |
| Pin Count | 8 |
TC7652CPA Overview
Packaged in a 8-DIP (0.300, 7.62mm) case, the buffer op amp is ready to use. There are two types of operational amplifiers in this circuit. There is a Tube case that is delivered with the instrumentation amplifiers. The total number of pins on linear amplifier is 8. I would like to remind you that this buffer op amp should be powered by an 5V battery. There are two types of Operational Amplifier op amps in this case, and this device falls into one of them. It has 8 pins that make up the linear amplifier. The input offset voltage is 5μV. This electronic part is best mounted with type Through Hole. It is important to note that this linear amplifier works well at a temperature of 0°C~70°C when it comes to operating temperatureIt is possible to operate this buffer amplifier from a supply current of 1mA . Maintain 150dB as the voltage gain. This op amp contains 1 circuits. The operating supply voltage of instrumentation amplifier is rated 8V voltage. It is important to keep the resistance within the 1 TΩ range of the linear amplifier. On the linear amplifier, there are 2 amplifiers that are used.
TC7652CPA Features
8 Pins
supply voltage of 5V
150dB voltage gain
Resistance of 1 TΩ
TC7652CPA Applications
There are a lot of Microchip Technology TC7652CPA Instrumentational OP Amps applications.
- Portable docking station
- Division circuits
- RF cable systems
- Voltage regulation circuit
- single/dual op amp sum and difference circuits
- Subtraction operation circuits
- Exponential operation circuits
- Thermocouples
- E-book readers
- Displayers for aircraft and air transportation control systems
