TDE1898RFPT
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 20-SOIC (0.295, 7.50mm Width) |
| Number of Pins | 20 |
| Operating Temperature | -25°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 3 (168 Hours) |
| Number of Terminations | 20 |
| ECCN Code | EAR99 |
| Technology | BCDMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Number of Functions | 1 |
| Supply Voltage | 24V |
| Current Rating | 500mA |
| Base Part Number | TDE189 |
| Pin Count | 20 |
| Number of Outputs | 1 |
| Output Type | N-Channel |
| Max Output Current | 500mA |
| Operating Supply Voltage | 35V |
| Interface | On/Off |
| Nominal Supply Current | 20mA |
| Output Configuration | High Side |
| Output Current | 500mA |
| Voltage - Supply (Vcc/Vdd) | Not Required |
| Max Supply Current | 20mA |
| Input Type | Differential |
| Switch Type | General Purpose |
| Min Input Voltage | 18V |
| Max Input Voltage | 35V |
| Ratio - Input:Output | 1:1 |
| Voltage - Load | 18V~35V |
| Fault Protection | Current Limiting (Fixed), Open Load Detect, Over Temperature, UVLO |
| Output Peak Current Limit-Nom | 0.75A |
| Built-in Protections | OVER CURRENT; THERMAL; UNDER VOLTAGE |
| Supply Voltage1-Min | 9V |
| Height Seated (Max) | 2.65mm |
| Width | 7.5mm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
TDE1898RFPT Overview
It's?packaged?in?the way?of?a?Tape & Reel (TR).It's included in the 20-SOIC (0.295, 7.50mm Width) package.Mounting type Surface Mount is selected for the LED driving board.It owns the General Purpose switch type.Ensure reliable operation by setting the temperature to -25°C~85°C TA.There are 1 outputs available on this lighting driver.In order to operate, it requires a voltage supply of Not Required.It has a maximum output voltage of N-Channel volts.As you can see, it comes from the TDE189 family.A total of 20 terminations have been found in it.The 20 pins are used to operate the LED driver.The LED driver has 1 functions.To meet the operation criteria, the maximum output current drops to 500mA.High efficiency is possible when the supply voltage is set to 24V.Surface Mount is mounted in the way of this LED driving board.20 pins are equipped with it.In this case, the output current will be set to 500mA.In order to maximize efficiency, the supply voltage should be set to 35V.This LED driving board can accept voltages up to 35V volts as an input.It has a 18V volt minimum input voltage.It has a maximum current requirement of 20mA.
TDE1898RFPT Features
Supplied from 24V
TDE1898RFPT Applications
There are a lot of STMicroelectronics TDE1898RFPT Power Switches ICs applications.
- Set-top-box
- Solid State Drivers
- Portable GPS
- Wearable Devices
- Notebook PC
- Telecom and Network Systems
- Hot Swap
- USB Power Distribution
- PC Card Hot Swap
- Hot Swaps
