TL026CDG4
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Package / Case | SOIC |
| Number of Pins | 8 |
| Weight | 72.603129mg |
| Packaging | Rail/Tube |
| JESD-609 Code | e4 |
| Moisture Sensitivity Level (MSL) | 2 |
| Number of Terminations | 8 |
| Terminal Finish | Nickel/Palladium/Gold (Ni/Pd/Au) |
| Max Operating Temperature | 70°C |
| Min Operating Temperature | 0°C |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 6V |
| Pin Count | 8 |
| Number of Elements | 1 |
| Temperature Grade | COMMERCIAL |
| Analog IC - Other Type | ANALOG CIRCUIT |
| Power Dissipation-Max | 725mW |
| Operating Supply Current | 22mA |
| Nominal Supply Current | 27mA |
| Power Dissipation | 725mW |
| Common Mode Rejection Ratio | 60 dB |
| Current - Input Bias | 30μA |
| Output Current per Channel | 4mA |
| Bandwidth | 50MHz |
| Neg Supply Voltage-Nom (Vsup) | -6V |
| Voltage Gain | 38.59dB |
| Max Dual Supply Voltage | 8V |
| -3db Bandwidth | 50MHz |
| Min Dual Supply Voltage | 3V |
| Dual Supply Voltage | 6V |
| Height | 1.58mm |
| Length | 4.9mm |
| Width | 3.91mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
TL026CDG4 Overview
Op amp is packaged in SOIC case. In the case of Rail/Tube cases, linear amplifier will be delivered. In recent months, the number of terminations has approached 8. Buffer amplifier has a total of 8 pins on it. It would be helpful if you could remember that this op amp ic should be powered by an 6V battery. A total of 8 pins are present on the instrumentation amplifier. This op amp can operate from a supply current at 22mA. There should be no change in the voltage gain at 38.59dB. The temperature should not be lower than 0°C for operational amplifier ics to operate. Instrumentation amplifier should only be used at temperatures up to 70°C. Depending on the chip's operating supply voltage, op amp ic has a rated voltage of 1. In order for this electronic part to be conducted successfully, you should use a dual supply voltage of 8V. In this linear amplifier, there is also an analog IC called a ANALOG CIRCUIT.
TL026CDG4 Features
8 Pins
supply voltage of 6V
38.59dB voltage gain
TL026CDG4 Applications
There are a lot of Texas Instruments TL026CDG4 Instrumentational OP Amps applications.
- RF cable systems
- Measurements of Wheatstone bridge
- Wireless base stations
- Information processing
- Industrial applications including automation
- Voltage regulation circuit
- Hand-held batteries
- Image computer boards
- Power generator
- Comparator
