TL064MFK
| Parameters | |
|---|---|
| Package / Case | LCC |
| Surface Mount | YES |
| Number of Pins | 20 |
| Pbfree Code | no |
| Number of Terminations | 20 |
| ECCN Code | EAR99 |
| Max Operating Temperature | 125°C |
| Min Operating Temperature | -55°C |
| Subcategory | Operational Amplifier |
| Packing Method | TUBE |
| Technology | BIPOLAR |
| Terminal Position | QUAD |
| Number of Functions | 4 |
| Supply Voltage | 15V |
| Pin Count | 20 |
| Power Supplies | +-15V |
| Temperature Grade | MILITARY |
| Number of Channels | 2 |
| Supply Current-Max | 1mA |
| Slew Rate | 3.5 V/μs |
| Architecture | VOLTAGE-FEEDBACK |
| Amplifier Type | OPERATIONAL AMPLIFIER |
| Common Mode Rejection Ratio | 80 dB |
| Current - Input Bias | 200pA |
| Gain Bandwidth Product | 1MHz |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| Unity Gain BW-Nom | 1000 kHz |
| Voltage Gain | 75.56dB |
| Low-Offset | NO |
| Frequency Compensation | YES |
| Max Dual Supply Voltage | 18V |
| Low-Bias | YES |
| Micropower | YES |
| Min Dual Supply Voltage | 3.5V |
| Screening Level | MIL-STD-883 |
| Max I/O Voltage | 9mV |
| Input Offset Voltage-Max | 15000μV |
| Length | 8.89mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Contains Lead |
TL064MFK Overview
Packaged in a LCC case, the buffer op amp is ready to use. An op amp of this type is a OPERATIONAL AMPLIFIER-type. There have been a total of 20 terminations over the past year. A total of 20 pins are located on this board. Please take in mind that this instrumentation amplifier should be run at 15V. A type of Operational Amplifier buffer op amp is what this device is specifically, to be more precise. In total, the buffer amplifier consists of 20 pins. There should be no change in the voltage gain. 2 channels are available on the instrumentation amplifier. This op amp needs to be operated at a temperature of not less than -55°C degrees Celsius in order to function properly. No temperature greater than 125°C should be used. A TUBE-shaped amplifier is used to pack the buffer amps. You should conduct this electronic component under the dual supply voltage of 18V.
TL064MFK Features
20 Pins
supply voltage of 15V
75.56dB voltage gain
TL064MFK Applications
There are a lot of Texas Instruments TL064MFK Instrumentational OP Amps applications.
- Large motor controllers
- Test equipment
- Proportional operation circuits
- Differentiator circuits
- Polarized electrodes
- Measurements of Wheatstone bridge
- High speed sample
- earphone
- Band-pass filter
- Power transmission
