TL594CDTBG
| Parameters | |
|---|---|
| Mounting Type | Surface Mount |
| Package / Case | 16-TSSOP (0.173, 4.40mm Width) |
| Surface Mount | YES |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| Series | SWITCHMODE™ |
| JESD-609 Code | e4 |
| Pbfree Code | yes |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| Terminal Finish | NICKEL PALLADIUM GOLD |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | 40 |
| Function | Step-Down, Step-Up/Step-Down |
| Number of Outputs | 2 |
| Qualification Status | COMMERCIAL |
| Output Type | Transistor Driver |
| Input Voltage-Nom | 15V |
| Analog IC - Other Type | SWITCHING CONTROLLER |
| Output Configuration | Positive |
| Voltage - Supply (Vcc/Vdd) | 7V~40V |
| Control Features | Dead Time Control, Frequency Control |
| Input Voltage (Min) | 7V |
| Topology | Buck, Push-Pull |
| Control Mode | VOLTAGE-MODE |
| Output Current-Max | 0.5A |
| Frequency - Switching | 300kHz |
| Input Voltage (Max) | 40V |
| Control Technique | PULSE WIDTH MODULATION |
| Synchronous Rectifier | Yes |
| Duty Cycle (Max) | 96% |
| Clock Sync | No |
| Output Phases | 1 |
| Length | 5mm |
| Width | 4.4mm |
| RoHS Status | ROHS3 Compliant |
TL594CDTBG Overview
With its 16-TSSOP (0.173, 4.40mm Width) package, the switching controller fits the needs of most applications. For 2 outputs, the dc motor controller is appropriate. There is a Tube solid enclosure around the pmic. Transistor Driver dc switching's outputs (s) are supported. 7V~40V is the operating voltage and supply voltage of the dc control. Suitable for a -40°C~85°C TA dc switcher. With this switching controller, you can switch at 300kHz. The Surface Mount makes it ideal for general dc dc regulator. Dead Time Control, Frequency Control is used for efficient switching control in the dcdc regulator. Connected to a SWITCHING CONTROLLER analog IC, the switch converters are connected to a power supply. The switching converters's terminals (s) are designed at DUAL. A variety of terminations with 16 of dc switching. A few of the control techniques these dc dc converter ics adapt include PULSE WIDTH MODULATION. DC switcher's voltage input is 15V. It is recommended to use 7V as the minimum input voltage of dc dc voltage regulator. The dc to dc regulator is limited to 40V input voltage. The output of this function is the greatest value of 0.5A. Basically, it's a dc to dc voltage regulator from the SWITCHMODE? series.
TL594CDTBG Features
Transistor Driver Outputs
Switching Frequency: 300kHz
Dead Time Control, Frequency Control
PULSE WIDTH MODULATION
TL594CDTBG Applications
There are a lot of Rochester Electronics, LLC TL594CDTBG DC to DC converter applications.
- Thermal power
- Die casting equipment
- Telecommunications equipment
- Domestic water pumps
- Wide-range voltage regulation circuits
- Packaging
- Arc suppression circuits
- Experimental setup
- Smoke prevention equipment
- Printing
