TLE2064MJB
| Parameters | |
|---|---|
| Length | 19.56mm |
| Width | 6.67mm |
| Thickness | 4.57mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Contains Lead |
| Lifecycle Status | ACTIVE (Last Updated: 3 days ago) |
| Package / Case | CDIP |
| Surface Mount | NO |
| Number of Pins | 14 |
| Number of Terminations | 14 |
| ECCN Code | EAR99 |
| Max Operating Temperature | 125°C |
| Min Operating Temperature | -55°C |
| Subcategory | Operational Amplifier |
| Packing Method | TUBE |
| Technology | BIFET |
| Terminal Position | DUAL |
| Terminal Form | THROUGH-HOLE |
| Number of Functions | 4 |
| Supply Voltage | 5V |
| Pin Count | 14 |
| Power Supplies | +-3.5/+-18/7/36V |
| Temperature Grade | MILITARY |
| Number of Channels | 4 |
| Slew Rate | 3.4 V/μs |
| Architecture | VOLTAGE-FEEDBACK |
| Amplifier Type | OPERATIONAL AMPLIFIER |
| Common Mode Rejection Ratio | 65 dB |
| Current - Input Bias | 30nA |
| Gain Bandwidth Product | 1.8MHz |
| Neg Supply Voltage-Nom (Vsup) | -5V |
| Unity Gain BW-Nom | 2000 kHz |
| Voltage Gain | 96.26dB |
| Average Bias Current-Max (IIB) | 0.00006μA |
| Low-Offset | NO |
| Frequency Compensation | YES |
| Max Dual Supply Voltage | 18V |
| Low-Bias | YES |
| Micropower | YES |
| Min Dual Supply Voltage | 3.5V |
| Bias Current-Max (IIB) @25C | 0.000003μA |
| Programmable Power | NO |
| Nominal Gain Bandwidth Product | 1.8MHz |
| Max I/O Voltage | 7mV |
| Input Offset Voltage-Max | 6000μV |
| Wideband | NO |
| Power | NO |
| Input Offset Current-Max (IIO) | 0.015μA |
| Height | 5.08mm |
TLE2064MJB Overview
A CDIP case is used to package the op amp. This is a OPERATIONAL AMPLIFIER type op amp. It is estimated that there will be 14 terminations in the next few months. A total of 14 pins are located on this board. The linear amplifier should be run at 5V at all times, so please keep that in mind when using it. It should be noted that this type of buffer amplifier is exactly what is known as a Operational Amplifier device. In total, the buffer amplifier consists of 14 pins. 96.26dB should remain the voltage gain. On the buffer amps, there are 4 channels that can be used. It is recommended that the temperature of this op amp ic should not fall below -55°C degrees Fahrenheit at any time. Use op amps only at temperatures no higher than 125°C. The linear amplifier is packaged by using a TUBE axis. There should be a dual supply voltage of 18V for you to conduct this electrical part.
TLE2064MJB Features
14 Pins
supply voltage of 5V
96.26dB voltage gain
TLE2064MJB Applications
There are a lot of Texas Instruments TLE2064MJB Instrumentational OP Amps applications.
- Commercial audio systems
- E-book readers
- Automatic control
- Biopotential
- Hand-held batteries
- Power generator
- Weak signal detection
- Signal operation
- pH (acidity)
- Information processing
