Parameters |
Mount |
Through Hole |
Mounting Type |
Through Hole |
Package / Case |
8-DIP (0.300, 7.62mm) |
Number of Pins |
8 |
Operating Temperature |
-40°C~125°C |
Packaging |
Tube |
JESD-609 Code |
e3 |
Part Status |
Obsolete |
Moisture Sensitivity Level (MSL) |
1 (Unlimited) |
Number of Terminations |
8 |
ECCN Code |
EAR99 |
Terminal Finish |
Matte Tin (Sn) - annealed |
Subcategory |
Operational Amplifier |
Technology |
CMOS |
Terminal Position |
DUAL |
Number of Functions |
2 |
Supply Voltage |
10V |
Base Part Number |
TS27M2 |
Pin Count |
8 |
Operating Supply Voltage |
8V |
Number of Elements |
2 |
Power Supplies |
5/10V |
Operating Supply Current |
150μA |
Nominal Supply Current |
400μA |
Output Current |
45mA |
Slew Rate |
0.6V/μs |
Architecture |
VOLTAGE-FEEDBACK |
Amplifier Type |
General Purpose |
Common Mode Rejection Ratio |
65 dB |
Current - Input Bias |
1pA |
Voltage - Supply, Single/Dual (±) |
3V~16V ±1.5V~8V |
Output Current per Channel |
45mA |
Input Offset Voltage (Vos) |
10mV |
Gain Bandwidth Product |
1MHz |
Unity Gain BW-Nom |
1000 kHz |
Voltage Gain |
93.98dB |
Average Bias Current-Max (IIB) |
0.0003μA |
Low-Offset |
NO |
Frequency Compensation |
YES |
Voltage - Input Offset |
1.1mV |
Low-Bias |
YES |
Micropower |
YES |
Programmable Power |
NO |
Wideband |
NO |
Power |
NO |
Height Seated (Max) |
5.33mm |
Radiation Hardening |
No |
RoHS Status |
ROHS3 Compliant |
Lead Free |
Lead Free |
TS27M2IN Overview
In order to protect the op amps, a 8-DIP (0.300, 7.62mm) case is used. There are two types of operational amplifiers in this circuit. As far as the packaging is concerned, buffer op amp is delivered in a Tube case. There is a growing number of terminations approaching the number of 8. The total number of pins on linear amplifier is 8. This linear amplifier should be powered by an 10V battery. To be specific, this instrumentation amplifier is a type of Operational Amplifier. 8 pins are located on the operational amplifiers. There is an input offset voltage of 10mV for this buffer op amp. This electronic part is recommended for mounting type Through Hole. The buffer amplifier functions well at -40°C~125°C as far as operating temperature is concerned. It is possible to operate this buffer amplifier from a supply current of 150μA . Maintain 93.98dB as the voltage gain. For the operating supply voltage of the op amp ic, there is a rating of 2. The operating supply voltage of instrumentation amplifier is rated 8V voltage.
TS27M2IN Features
8 Pins
supply voltage of 10V
93.98dB voltage gain
TS27M2IN Applications
There are a lot of STMicroelectronics TS27M2IN Instrumentational OP Amps applications.
- Precision measurement
- Large motor controllers
- Fission chambers
- Radar
- High-frequency data acquisition systems
- Video conversion and routing
- Blood pressure sensors
- Weak signal detection
- pH (acidity)
- Signal filtering