Parameters |
Contact Plating |
Gold |
Mount |
Surface Mount |
Mounting Type |
Surface Mount |
Package / Case |
SOT-23-6 |
Number of Pins |
6 |
Weight |
6.492041mg |
Operating Temperature |
-40°C~85°C TA |
Packaging |
Tape & Reel (TR) |
JESD-609 Code |
e4 |
Pbfree Code |
yes |
Part Status |
Active |
Moisture Sensitivity Level (MSL) |
1 (Unlimited) |
Number of Terminations |
6 |
Termination |
SMD/SMT |
ECCN Code |
EAR99 |
Resistance |
900mOhm |
Subcategory |
Multiplexer or Switches |
Terminal Position |
DUAL |
Terminal Form |
GULL WING |
Peak Reflow Temperature (Cel) |
260 |
Number of Functions |
1 |
Supply Voltage |
1.8V |
Terminal Pitch |
0.95mm |
Base Part Number |
TS5A3159 |
Pin Count |
6 |
Number of Outputs |
2 |
Polarity |
Non-Inverting |
Number of Channels |
1 |
Max Supply Voltage |
5.5V |
Min Supply Voltage |
1.65V |
Operating Supply Current |
100nA |
Max Supply Current |
50nA |
Turn On Delay Time |
30 ns |
Supply Type |
Single |
Bandwidth |
100MHz |
Turn-Off Delay Time |
20 ns |
On-State Resistance (Max) |
900mOhm |
High Level Output Current |
200mA |
Low Level Output Current |
200mA |
Multiplexer/Demultiplexer Circuit |
2:1 |
Off-state Isolation-Nom |
64 dB |
Current - Leakage (IS(off)) (Max) |
20nA |
Channel Capacitance (CS(off), CD(off)) |
18pF |
On-state Resistance Match-Nom |
0.15Ohm |
Switch Circuit |
SPDT |
Switch Time (Ton, Toff) (Max) |
30ns, 20ns |
Charge Injection |
-20pC |
Channel-to-Channel Matching (ΔRon) |
50m Ω |
Crosstalk |
-64dB @ 1MHz |
Switching |
BREAK-BEFORE-MAKE |
Switch-on Time-Max |
75ns |
Switch-off Time-Max |
50ns |
Voltage - Supply, Single (V+) |
1.65V~5.5V |
Drain to Source Resistance |
900mOhm |
Ambient Temperature Range High |
85°C |
On-State Resistance |
1Ohm |
Height |
1.45mm |
Length |
2.9mm |
Width |
1.6mm |
Thickness |
1.2mm |
Radiation Hardening |
No |
REACH SVHC |
No SVHC |
RoHS Status |
ROHS3 Compliant |
Lead Free |
Lead Free |
Factory Lead Time |
1 Week |
Lifecycle Status |
ACTIVE (Last Updated: 5 days ago) |
TS5A3159ADBVR Overview
Shipping overseas is convenient with the electronic component packed in SOT-23-6. In order to provide high reliability, an advanced packaging method Tape & Reel (TR) is used. The multiplexer is located in Surface Mount. There is 2:1 ratio between the number of multiplexers and demultiplexers. Operating temperature extended to -40°C~85°C TA. 6 terminations have been made so far. A 1 channel electronic part produces high-quality output. An 1.8V voltage supply should allow the electrical part to be turned on and run. An electrical component of this type can be found in the 6 series. These analog multiplexers are built based on SPDT switching circuits. Try searching with TS5A3159 to find analog multiplexer variants. In this multiplexer, the internal resistance is 900mOhm. The datasheets for the 6 pins explain the functions. There is a standard Multiplexer or Switches analogue multiplexer here. Multiplexers should not be powered above 5.5V in normal situations. Analogue multiplexers of the Single supply type that are cost-effective. 1.65V is the lowest voltage that should be fed to the electronic electronic part. In order to operate this switch device, it would need a current of 100nA. The voltage required by this switch device is 1.65V~5.5V, draining from a single voltage supply. The switch multiplexer may be damaged if it is exposed to voltage greater than 50nA. 100MHz bandwidths enable data to be transferred. The Drain to Source resistance of this electronic component is 900mOhm. This digital multiplexer has 2 outputs.
TS5A3159ADBVR Features
1 Channels
Switch Circuit: SPDT
100nA Supply Current
Bandwidth: 100MHz
Drain-to-Source resistance: 900mOhm
TS5A3159ADBVR Applications
There are a lot of Texas Instruments TS5A3159ADBVR Analog Switches & Multiplexers ICs applications.
- Optical Applications
- PDH Multiplexers
- Digital access cross connects
- Microprocessor Controlled Analog Systems
- Automatic test equipment
- Sample hold systems
- Cell phones
- ADCs such as AD7840/8, AD7870/1/2/4/5/6/8
- PBXs
- Relay Replacement