TS5A3357DCUT

6.5ns, 3.7ns SP3T 15Ohm DUAL Analog Switches BREAK-BEFORE-MAKE TS5A3357 8 Pins 100nA 1.8V 8-VFSOP (0.091, 2.30mm Width)

Manufacturer: Texas Instruments
Nocochips NO: 815-TS5A3357DCUT
Package: 8-VFSOP (0.091, 2.30mm Width)
Datasheet: -
Stock: 145
Description: 6.5ns, 3.7ns SP3T 15Ohm DUAL Analog Switches BREAK-BEFORE-MAKE TS5A3357 8 Pins 100nA 1.8V 8-VFSOP (0.091, 2.30mm Width)(Kg)

Details

Tags

Parameters
Factory Lead Time	1 Week
Lifecycle Status	ACTIVE (Last Updated: 6 days ago)
Contact Plating	Gold
Mount	Surface Mount
Mounting Type	Surface Mount
Package / Case	8-VFSOP (0.091, 2.30mm Width)
Number of Pins	8
Weight	9.610488mg
Operating Temperature	-40°C~85°C TA
Packaging	Tape & Reel (TR)
JESD-609 Code	e4
Pbfree Code	yes
Part Status	Active
Moisture Sensitivity Level (MSL)	1 (Unlimited)
Number of Terminations	8
Resistance	15Ohm
Subcategory	Multiplexer or Switches
Terminal Position	DUAL
Terminal Form	GULL WING
Peak Reflow Temperature (Cel)	260
Number of Functions	1
Supply Voltage	1.8V
Terminal Pitch	0.5mm
Base Part Number	TS5A3357
Pin Count	8
Number of Outputs	3
Polarity	Non-Inverting
Number of Channels	1
Max Supply Voltage	5.5V
Min Supply Voltage	1.65V
Operating Supply Current	1μA
Nominal Supply Current	1μA
Max Supply Current	1μA
Turn On Delay Time	6.5 ns
Number of Inputs	1
Supply Type	Single
Bandwidth	334MHz
Turn-Off Delay Time	3.7 ns
On-State Resistance (Max)	15Ohm
High Level Output Current	100mA
Low Level Output Current	100mA
Multiplexer/Demultiplexer Circuit	3:1
Off-state Isolation-Nom	81 dB
Current - Leakage (IS(off)) (Max)	100nA
Channel Capacitance (CS(off), CD(off))	4.5pF 10.5pF
On-state Resistance Match-Nom	0.3Ohm
Switch Circuit	SP3T
Switch Time (Ton, Toff) (Max)	6.5ns, 3.7ns
Charge Injection	3.4pC
Channel-to-Channel Matching (ΔRon)	100m Ω
Crosstalk	-62dB @ 10MHz
Switching	BREAK-BEFORE-MAKE
Voltage - Supply, Single (V+)	1.65V~5.5V
Drain to Source Resistance	5Ohm
Height	900μm
Length	2.3mm
Width	2mm
Thickness	850μm
Radiation Hardening	No
REACH SVHC	No SVHC
RoHS Status	ROHS3 Compliant
Lead Free	Lead Free

TS5A3357DCUT Overview

Shipping overseas is convenient with the electronic component packed in 8-VFSOP (0.091, 2.30mm Width). This high-reliability packaging method uses advanced packaging methods Tape & Reel (TR). Surface Mount is where this multiplexer is located. 3:1 is the ratio between multiplexers and demultiplexers. Extended operating temperature around -40°C~85°C TA. Total terminations are 8. A 1 channel electronic part produces high-quality output. If the voltage supply is 1.8V volts, the electrical component should be turned on and run. A key feature of the 8 series is the inclusion of this electronic part as part of its design. Based on SP3T switching circuits, these analog multiplexers work. Using the TS5A3357 search parameter, you can discover variants of the switch. This digital multiplexer has 15Ohm internal resistance. For details about the functions of 8 pins, please refer to the datasheets. A analogue multiplexer of this type is a Multiplexer or Switches. Multiplexers should not be powered above 5.5V in normal situations. A analog switch ic that has a cost-effective Single supply type. 1.65V is the lowest voltage that should be fed to the electronic electronic part. It would be sufficient to run this analogue multiplexer with 1μA current. Using only a single voltage supply, this analog switch requires 1.65V~5.5V voltage. A voltage higher than 1μA may cause damage to the switch multiplexer. It is possible to operate 1 inputs. The transfer of data can be performed over 334MHz bandwidths. It has a Drain to Source resistance of 5Ohm ohms. This digital multiplexer has 3 outputs.