UC2524N
| Parameters | |
|---|---|
| Mounting Type | Through Hole |
| Package / Case | 16-DIP (0.300, 7.62mm) |
| Surface Mount | NO |
| Operating Temperature | -25°C~85°C TA |
| Packaging | Tube |
| JESD-609 Code | e4 |
| Pbfree Code | yes |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 3 (168 Hours) |
| Number of Terminations | 16 |
| Terminal Finish | NICKEL PALLADIUM GOLD |
| Technology | BIPOLAR |
| Terminal Position | DUAL |
| Function | Step-Up, Step-Up/Step-Down |
| Number of Outputs | 2 |
| Output Voltage | 5V |
| Output Type | Transistor Driver |
| Input Voltage-Nom | 20V |
| Analog IC - Other Type | SWITCHING CONTROLLER |
| Output Configuration | Positive |
| Voltage - Supply (Vcc/Vdd) | 8V~40V |
| Control Features | Current Limit, Enable, Frequency Control, Ramp |
| Input Voltage (Min) | 8V |
| Topology | Boost, Flyback, Forward Converter, Full-Bridge, Half-Bridge, Push-Pull |
| Control Mode | VOLTAGE-MODE |
| Frequency - Switching | 300kHz |
| Input Voltage (Max) | 40V |
| Control Technique | PULSE WIDTH MODULATION |
| Synchronous Rectifier | No |
| Duty Cycle (Max) | 45% |
| Output Phases | 1 |
| Height Seated (Max) | 5.08mm |
| RoHS Status | ROHS3 Compliant |
UC2524N Overview
It comes in the 16-DIP (0.300, 7.62mm) package, which makes switching controller suitable for most applications. 2 outputs are supported by the dc motor controller. Tube is the solid enclosure in which PMIC is packaged. A total of Transistor Driver dc switching's outputs can be handled by it. DC control operates at 8V~40V volts and has 8V~40V supply voltage. Worked in a -25°C~85°C TA dc switcher before. In this switching controller, the switch can be set to 300kHz. It is suitable for general dc dc regulator when it is set to Through Hole. To provide efficient switching control, Current Limit, Enable, Frequency Control, Ramp is included in the dcdc regulator. An analog IC SWITCHING CONTROLLER is connected to the switch converters. A switching converters's terminal (s) sits at the DUAL position. There are many different types of terminations for 16. A few of the control techniques these dc dc converter ics adapt include PULSE WIDTH MODULATION. DC switcher's input voltageis 20V volts. 8V should be the minimum input voltage for the dc dc voltage regulator. A 5V voltage of DC regulator was detected in the test statistics. Voltages 40V are the maximum that the dc to dc regulator will accept.
UC2524N Features
Transistor Driver Outputs
Switching Frequency: 300kHz
Current Limit, Enable, Frequency Control, Ramp
PULSE WIDTH MODULATION
UC2524N Applications
There are a lot of Rochester Electronics, LLC UC2524N DC to DC converter applications.
- Current source circuits
- Bending machines
- Planers
- Terrestrial set-top boxes
- Smoke prevention equipment
- Direct power supply system
- seismic instrument power circuits
- Surge protection circuits
- Printing equipment
- Drilling machines
