Parameters |
Mount |
Surface Mount |
Mounting Type |
Surface Mount |
Package / Case |
16-SSOP (0.154, 3.90mm Width) |
Number of Pins |
16 |
Operating Temperature |
0°C~70°C TA |
Packaging |
Tube |
Part Status |
Obsolete |
Moisture Sensitivity Level (MSL) |
2 (1 Year) |
Number of Terminations |
16 |
ECCN Code |
EAR99 |
Subcategory |
Peripheral Drivers |
Terminal Position |
DUAL |
Terminal Form |
GULL WING |
Supply Voltage |
25V |
Terminal Pitch |
0.635mm |
Base Part Number |
UC37136 |
Pin Count |
16 |
Number of Outputs |
2 |
Output Type |
Bipolar |
Max Output Current |
1.3A |
Operating Supply Voltage |
65V |
Interface |
On/Off |
Nominal Supply Current |
7mA |
Output Configuration |
High Side or Low Side |
Output Current |
250mA |
Voltage - Supply (Vcc/Vdd) |
Not Required |
Max Supply Current |
7mA |
Input Type |
Non-Inverting |
Switch Type |
General Purpose |
Min Input Voltage |
8V |
Max Input Voltage |
65V |
Output Current per Channel |
250mA |
Ratio - Input:Output |
1:1 |
Voltage - Load |
9V~35V |
Driver Number of Bits |
2 |
Fault Protection |
Current Limiting (Fixed), Over Temperature, UVLO |
Output Peak Current Limit-Nom |
1.1A |
Radiation Hardening |
No |
RoHS Status |
ROHS3 Compliant |
Lead Free |
Lead Free |
UC37136MG4 Overview
A Tube is used to package it.There is a package for it in the 16-SSOP (0.154, 3.90mm Width) package.In this case, the LED driving board is mounted as Surface Mount.General Purpose is the switch type it owns.It is recommended that the temperature be set to 0°C~70°C TA for reliable operation.The LED driver is equipped with 2 outputs.It uses a supply voltage of Not Required to operate.There is a maximum output voltage of Bipolar volts.It comes under the family of UC37136.There are 16 terminations in it.During operation, the 16 pins are used.The maximum output current drops to 1.3A in order to meet the operation criteria.With a supply voltage of 25V, high efficiency is possible.Surface Mount is mounted in the way of this lighting driver.A total of 16 pins are present on it.This results in a 250mA output current.Self-contained LED driver with Peripheral Drivers capacity in an econtainer.In order to optimize the efficiency of the supply voltage, it should be set to 65V.This LED driver can handle voltages up to 65V volts.It requires 8V volts as the minimum input voltage.For its operation, a maximum current requirement of 7mA is required.
UC37136MG4 Features
Supplied from 25V
UC37136MG4 Applications
There are a lot of Texas Instruments UC37136MG4 Power Switches ICs applications.
- USB3.1 Power Delivery
- Solid State Drivers
- Hot Swap
- Gaming
- PDAs
- PC Cards
- Wireless Headsets
- USB Power Distribution
- Low Voltage I/O System Power
- Telecom and Network Systems