VN7140AS-E
| Parameters | |
|---|---|
| Max Output Current | 8A |
| Supply Voltage-Min (Vsup) | 4V |
| Interface | On/Off |
| Nominal Supply Current | 3mA |
| Output Configuration | High Side |
| Output Current | 8A |
| Voltage - Supply (Vcc/Vdd) | Not Required |
| Max Supply Current | 5mA |
| Input Type | Non-Inverting |
| Turn On Delay Time | 120 μs |
| Switch Type | General Purpose |
| Turn-Off Delay Time | 100 μs |
| Ratio - Input:Output | 1:1 |
| Voltage - Load | 4V~28V |
| Fault Protection | Current Limiting (Fixed), Open Load Detect, Over Temperature, Over Voltage, UVLO |
| Rds On (Typ) | 140m Ω |
| Built-in Protections | TRANSIENT; OVER CURRENT; OVER VOLTAGE; THERMAL; UNDER VOLTAGE |
| Length | 4.9mm |
| Width | 3.9mm |
| Radiation Hardening | No |
| REACH SVHC | No SVHC |
| RoHS Status | ROHS3 Compliant |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 8-SOIC (0.154, 3.90mm Width) |
| Number of Pins | 8 |
| Operating Temperature | -40°C~150°C TJ |
| Packaging | Tube |
| Series | VIPower™ |
| Feature | Auto Restart, Status Flag |
| Part Status | Discontinued |
| Moisture Sensitivity Level (MSL) | 3 (168 Hours) |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Number of Functions | 1 |
| Supply Voltage | 13V |
| Base Part Number | VN7140 |
| Number of Outputs | 1 |
| Output Type | N-Channel |
VN7140AS-E Overview
As you can see, it's packaged in the way of a Tube.The 8-SOIC (0.154, 3.90mm Width) package contains it.The LED driver is mounted as Surface Mount.General Purpose is the type of switch owned by it.It is best to set the temperature to -40°C~150°C TJ to ensure reliable operation.The LED driver has 1 outputs.The LED driving board is powered by a voltage of Not Required.Voltage output is N-Channel volts at maximum.As far as features are concerned, the LED driving board has Auto Restart, Status Flag.It belongs to the family VN7140.There are 8 terminations in it.In order to operate, the 8 pins are used.It contains 1 functions.As a result, the maximum output current is reduced to 8A in order to meet the operation requirements.Supply voltages of 13V allow for high efficiency.It is mounted in the way of Surface Mount.It is part of the VIPower? series.In this case, the output current is set to 8A.In order to operate normally, the supply voltage (Vsup) must remain above 4V.5mA is the maximum current required to operate it.
VN7140AS-E Features
Supplied from 13V
VN7140AS-E Applications
There are a lot of STMicroelectronics VN7140AS-E Power Switches ICs applications.
- Storage Drives
- PC Card Hot Swap
- USB Power Distribution
- HDD and SSD
- Portable Video Game Players
- Hot Swaps
- Portable GPS Device
- Notebook and Tablet Computers
- Wireless Modem Data Cards
- Hard Disk Drives
