VNB14N04TR-E
| Parameters | |
|---|---|
| Switch Type | General Purpose |
| Ratio - Input:Output | 1:1 |
| Voltage - Load | 35V Max |
| Fault Protection | Current Limiting (Fixed), Over Temperature, Over Voltage |
| Rds On (Typ) | 70m Ω (Max) |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | TO-263-3, D2Pak (2 Leads + Tab), TO-263AB |
| Number of Pins | 3 |
| Packaging | Tape & Reel (TR) |
| Series | OMNIFET™, VIPower™ |
| JESD-609 Code | e3 |
| Feature | Status Flag |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 3 (168 Hours) |
| ECCN Code | EAR99 |
| Resistance | 70mOhm |
| Terminal Finish | Matte Tin (Sn) - annealed |
| Max Power Dissipation | 50W |
| Peak Reflow Temperature (Cel) | 245 |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Base Part Number | VNB14 |
| Number of Outputs | 1 |
| Output Type | N-Channel |
| Max Output Current | 14A |
| Operating Supply Voltage | 18V |
| Interface | On/Off |
| Nominal Supply Current | 250μA |
| Output Configuration | Low Side |
| Power Dissipation | 50W |
| Output Current | 10A |
| Voltage - Supply (Vcc/Vdd) | Not Required |
| Max Supply Current | 250μA |
| Input Type | Non-Inverting |
VNB14N04TR-E Overview
Tape & Reel (TR) is how it's packaged.In the TO-263-3, D2Pak (2 Leads + Tab), TO-263AB package, it is included.A Surface Mount mounting is used for the LED driving board.General Purpose is the switch type that it owns.As a default, the output is set to 1.In order to operate, it requires a voltage supply of Not Required.A maximum voltage of N-Channel volts is available from the output of this LED driver.It is equipped with Status Flag features.I believe it belongs to the VNB14 family.The 3 pins are used to operate the LED driver.This operation requires the maximum output current to be decreased to 14A.In this case, it is mounted in the way of Surface Mount.It has a resistance of 70mOhm.There is an electrical component included in the OMNIFET?, VIPower? series.It is set to 10A in this case.When using this LED driving board, it is recommended that the supply voltage is set to 18V.For its operation, a current of 250μA is required.
VNB14N04TR-E Features
Resistance of 70mOhm
VNB14N04TR-E Applications
There are a lot of STMicroelectronics VNB14N04TR-E Power Switches ICs applications.
- PC Cards
- Wearable Devices
- PC Card Hot Swap
- Solid State Drivers
- Solid-State Drives
- USB Power Distribution
- HDD, SSD
- Storage (HDDs, SSDs)
- PDAs
- Hot Swap
