banner_page

VND10N06

N-Channel PMIC OMNIFET?, VIPower? Series VND10 3 Pin TO-252-3, DPak (2 Leads + Tab), SC-63


  • Manufacturer: STMicroelectronics
  • Nocochips NO: 761-VND10N06
  • Package: TO-252-3, DPak (2 Leads + Tab), SC-63
  • Datasheet: PDF
  • Stock: 125
  • Description: N-Channel PMIC OMNIFET?, VIPower? Series VND10 3 Pin TO-252-3, DPak (2 Leads + Tab), SC-63 (Kg)

Details

Tags

Parameters
Lifecycle Status ACTIVE (Last Updated: 8 months ago)
Mount Surface Mount
Mounting Type Surface Mount
Package / Case TO-252-3, DPak (2 Leads + Tab), SC-63
Number of Pins 3
Weight 329.988449mg
Packaging Tube
Series OMNIFET™, VIPower™
Part Status Obsolete
Moisture Sensitivity Level (MSL) 3 (168 Hours)
ECCN Code EAR99
Resistance 150mOhm
Voltage - Rated DC 60V
Max Power Dissipation 35W
Current Rating 10A
Base Part Number VND10
Pin Count 3
Number of Outputs 1
Output Type N-Channel
Max Output Current 10A
Interface On/Off
Nominal Supply Current 150μA
Output Configuration Low Side
Power Dissipation 35W
Output Current 6A
Voltage - Supply (Vcc/Vdd) Not Required
Max Supply Current 150μA
Input Type Non-Inverting
Switch Type General Purpose
Continuous Drain Current (ID) 10A
Ratio - Input:Output 1:1
Fault Protection Current Limiting (Fixed), Over Temperature, Over Voltage
Drain to Source Breakdown Voltage 60V
Rds On (Typ) 150m Ω
Drain to Source Resistance 300mOhm
Radiation Hardening No
RoHS Status ROHS3 Compliant

VND10N06 Overview


It is packaged in the form of a Tube.It is included in the package TO-252-3, DPak (2 Leads + Tab), SC-63.Surface Mount is the mounting type of the LED driver.It owns the General Purpose switch type.It is possible to use 1 outputs in the lighting driver.In order to operate, it requires a voltage supply of Not Required.The maximum output voltage is N-Channel volts.It is part of the VND10 family of LED drivers.For operation, we use the 3 pins.This operation requires the maximum output current to be decreased to 10A.The LED driving board is mounted in the way of Surface Mount.3 pins are connected to it in total.The LED driver has 150mOhm resistance.There is an electrical component included in the OMNIFET?, VIPower? series.This results in a 6A output current.The maximum current required for its operation is 150μA.

VND10N06 Features


Resistance of 150mOhm

VND10N06 Applications


There are a lot of STMicroelectronics VND10N06 Power Switches ICs applications.

  • USB Power Distribution
  • Low Voltage I/O System Power
  • Set-Top Boxes
  • USB Ports/Hubs
  • Portable GPS
  • Notebook and Tablet Computers
  • USB3.1 Power Delivery
  • Hot-Swap Systems
  • USB Power Distribution
  • Storage Drives

Write a review

Note: HTML is not translated!
    Bad           Good