banner_page

VND1NV04-1-E

N-Channel PMIC OMNIFET II?, VIPower? Series VND1N 3 Pin TO-252-3, DPak (2 Leads + Tab), SC-63


  • Manufacturer: STMicroelectronics
  • Nocochips NO: 761-VND1NV04-1-E
  • Package: TO-252-3, DPak (2 Leads + Tab), SC-63
  • Datasheet: PDF
  • Stock: 607
  • Description: N-Channel PMIC OMNIFET II?, VIPower? Series VND1N 3 Pin TO-252-3, DPak (2 Leads + Tab), SC-63 (Kg)

Details

Tags

Parameters
Factory Lead Time 1 Week
Lifecycle Status ACTIVE (Last Updated: 7 months ago)
Mount Through Hole
Mounting Type Surface Mount
Package / Case TO-252-3, DPak (2 Leads + Tab), SC-63
Number of Pins 3
Operating Temperature -40°C~150°C TJ
Packaging Tube
Series OMNIFET II™, VIPower™
Part Status Active
Moisture Sensitivity Level (MSL) 1 (Unlimited)
Resistance 250mOhm
Base Part Number VND1N
Number of Outputs 1
Output Type N-Channel
Max Output Current 1.7A
Interface On/Off
Element Configuration Single
Nominal Supply Current 100μA
Output Configuration Low Side
Output Current -3A
Voltage - Supply (Vcc/Vdd) Not Required
Max Supply Current 100μA
Input Type Non-Inverting
Switch Type General Purpose
Rise Time 500ns
Fall Time (Typ) 600 ns
Continuous Drain Current (ID) 20A
Ratio - Input:Output 1:1
Voltage - Load 36V Max
Fault Protection Current Limiting (Fixed), Over Temperature, Over Voltage
Rds On (Typ) 250m Ω (Max)
Radiation Hardening No
RoHS Status ROHS3 Compliant

VND1NV04-1-E Overview


It is packaged in the manner of a Tube.It is included with the TO-252-3, DPak (2 Leads + Tab), SC-63 package as well.The lighting driver is mounted in the Surface Mount position.The switch type of this switch is General Purpose.The temperature should be set to -40°C~150°C TJ to ensure reliable functioning.The LED driver has a total of 1 outputs.It uses a supply voltage of Not Required to operate.There is a maximum output voltage of N-Channel volts on this LED driver.It comes under the family of VND1N.In order to operate, 3 pins are used.This operation requires the maximum output current to be decreased to 1.7A.As a result, it is mounted in the manner of Through Hole.It has a resistance of 250mOhm.Electrical components such as this are included in the OMNIFET II?, VIPower? series.It is set to -3A in this case.A maximum current requirement of 100μA is required for its operation.

VND1NV04-1-E Features


Resistance of 250mOhm

VND1NV04-1-E Applications


There are a lot of STMicroelectronics VND1NV04-1-E Power Switches ICs applications.

  • Smartphone and PDA
  • PC Card Hot Swap
  • PDAs
  • Hot Swap
  • HDD, SSD
  • Storage Drives
  • Portable/Handheld Devices
  • USB Ports/Hubs
  • Solid-State Drives
  • USB Power Distribution

Write a review

Note: HTML is not translated!
    Bad           Good