VND830ASP-E
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | PowerSO-10 Exposed Bottom Pad |
| Number of Pins | 10 |
| Operating Temperature | -40°C~150°C TJ |
| Packaging | Tube |
| Series | VIPower™ |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 3 (168 Hours) |
| ECCN Code | EAR99 |
| Resistance | 60mOhm |
| Max Power Dissipation | 74W |
| Base Part Number | VND830 |
| Pin Count | 10 |
| Number of Outputs | 2 |
| Output Type | N-Channel |
| Max Output Current | 10A |
| Operating Supply Voltage | 36V |
| Interface | On/Off |
| Nominal Supply Current | 7mA |
| Output Configuration | High Side |
| Power Dissipation | 74W |
| Output Current | 6A |
| Voltage - Supply (Vcc/Vdd) | Not Required |
| Max Supply Current | 7mA |
| Input Type | Non-Inverting |
| Switch Type | General Purpose |
| Min Input Voltage | 5.5V |
| Max Input Voltage | 36V |
| Ratio - Input:Output | 1:1 |
| Voltage - Load | 5.5V~36V |
| Fault Protection | Current Limiting (Fixed), Over Temperature, Over Voltage |
| Rds On (Typ) | 60m Ω (Max) |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
VND830ASP-E Overview
A Tube is used to package it.Package PowerSO-10 Exposed Bottom Pad contains it.Mounting type Surface Mount is selected for the LED driving board.General Purpose is the switch type that it owns.The temperature should be set to -40°C~150°C TJ to ensure reliable functioning.The LED driver is equipped with 2 outputs.The LED driving board is powered by a voltage of Not Required.A maximum output voltage of N-Channel volts can be obtained with this LED driver.It belongs to the VND830 family.For operation, we use the 10 pins.To comply with the operation criteria, the maximum output current is reduced to 10A.It is positioned in the direction of Surface Mount.As a result, it has a total of 10 pins.Lighting drivers with 60mOhm resistance are used.A component of this type is included in the VIPower? series.It is set to 6A in this case.It is recommended that the supply voltage be set at 36V in order to achieve maximum efficiency.There is a maximum input voltage of 36V volts.The minimum input voltage is 5.5V volts.For its operation, a current of 7mA is required.
VND830ASP-E Features
Resistance of 60mOhm
VND830ASP-E Applications
There are a lot of STMicroelectronics VND830ASP-E Power Switches ICs applications.
- HDD, SSD
- USB3.1 Power Delivery
- Smart Phones, Feature Phones
- USB Power Distribution
- Wireless Headsets
- Various applications equipped with buttons
- Hard Disk Drives
- Low Voltage I/O System Power
- HDD and SSD
- Solid-State Drives
