VNV10N07-E
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Lifecycle Status | NRND (Last Updated: 6 months ago) |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | PowerSO-10 Exposed Bottom Pad |
| Number of Pins | 10 |
| Packaging | Tube |
| Series | OMNIFET™, VIPower™ |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 3 (168 Hours) |
| Resistance | 100mOhm |
| Max Power Dissipation | 50W |
| Base Part Number | VNV10 |
| Number of Outputs | 1 |
| Output Type | N-Channel |
| Max Output Current | 10A |
| Operating Supply Voltage | 18V |
| Interface | On/Off |
| Nominal Supply Current | 250μA |
| Output Configuration | Low Side |
| Power Dissipation | 50W |
| Output Current | 7A |
| Voltage - Supply (Vcc/Vdd) | Not Required |
| Max Supply Current | 250μA |
| Input Type | Non-Inverting |
| Switch Type | General Purpose |
| Output Current per Channel | 7A |
| Continuous Drain Current (ID) | 10A |
| Ratio - Input:Output | 1:1 |
| Voltage - Load | 55V Max |
| Fault Protection | Current Limiting (Fixed), Over Temperature, Over Voltage |
| Drain to Source Breakdown Voltage | 70V |
| Rds On (Typ) | 100m Ω (Max) |
| Drain to Source Resistance | 100mOhm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
VNV10N07-E Overview
It's?packaged?in?the way?of?a?Tube.The PowerSO-10 Exposed Bottom Pad package includes it.The lighting driver has the mounting type Surface Mount.The switch type is General Purpose.The LED driver has a total of 1 outputs.It uses a supply voltage of Not Required to operate.It produces a maximum output voltage of N-Channel volts at its maximum output.The VNV10 family consists of this type.10 pins are used for operation.It is necessary to reduce the maximum output current to 10A to meet the operation criteria.The lighting driver is mounted in the direction of Surface Mount.There is 100mOhm resistance on the LED driver.Electrical components such as this are included in the OMNIFET?, VIPower? series.In this case, the output current will be set to 7A.The supply voltage should be set at 18V for best efficiency.It has a maximum current requirement of 250μA.
VNV10N07-E Features
Resistance of 100mOhm
VNV10N07-E Applications
There are a lot of STMicroelectronics VNV10N07-E Power Switches ICs applications.
- Hot-Swap Systems
- Wireless Headsets
- Portable GPS
- Set-Top Boxes
- Wireless/Networking Cards
- Portable Devices
- Set-top-box
- Notebook PC
- Solid State Drivers
- Notebook and Tablet Computers
