Parameters |
Mount |
Surface Mount |
Mounting Type |
Surface Mount |
Package / Case |
PowerSO-10 Exposed Bottom Pad |
Number of Pins |
12 |
Packaging |
Tape & Reel (TR) |
Series |
OMNIFET™, VIPower™ |
Part Status |
Obsolete |
Moisture Sensitivity Level (MSL) |
1 (Unlimited) |
Number of Terminations |
10 |
ECCN Code |
EAR99 |
Resistance |
100mOhm |
Max Power Dissipation |
50W |
Technology |
MOS |
Terminal Position |
DUAL |
Terminal Form |
GULL WING |
Number of Functions |
1 |
Base Part Number |
VNV10 |
Pin Count |
10 |
Number of Outputs |
1 |
Output Type |
N-Channel |
Max Output Current |
7A |
Operating Supply Voltage |
18V |
Interface |
On/Off |
Nominal Supply Current |
250μA |
Output Configuration |
Low Side |
Power Dissipation |
50W |
Output Current |
7A |
Voltage - Supply (Vcc/Vdd) |
Not Required |
Max Supply Current |
250μA |
Input Type |
Non-Inverting |
Switch Type |
General Purpose |
Ratio - Input:Output |
1:1 |
Voltage - Load |
55V Max |
Fault Protection |
Current Limiting (Fixed), Over Temperature, Over Voltage |
Turn On Time |
0.9 μs |
Output Peak Current Limit-Nom |
10A |
Rds On (Typ) |
100m Ω (Max) |
Turn Off Time |
6 μs |
Built-in Protections |
OVER CURRENT; THERMAL; ZENER CLAMP |
Height Seated (Max) |
3.75mm |
Length |
9.4mm |
Width |
7.5mm |
Radiation Hardening |
No |
RoHS Status |
ROHS3 Compliant |
VNV10N0713TR Overview
It is packaged in the form of a Tape & Reel (TR).It is included in the package PowerSO-10 Exposed Bottom Pad.The lighting driver has the mounting type Surface Mount.A General Purpose switch type is owned by it.The LED driver has 1 outputs.In order to operate, it requires a voltage supply of Not Required.There is a maximum output voltage of N-Channel volts.It comes under the family of VNV10.It has a total of 10 terminations.For operation, we use the 12 pins.The LED driver has 1 functions.In order to meet the operation criteria, the maximum output current drops to 7A.It is positioned in the direction of Surface Mount.This LED driver is equipped with a total of 10 pins.In this LED driving board, there is 100mOhm resistance.It belongs to the OMNIFET?, VIPower? series.The output current is set to 7A in this case.In order to optimize the efficiency of the supply voltage, it should be set to 18V.There is a maximum current requirement of 250μA for its operation.
VNV10N0713TR Features
Resistance of 100mOhm
VNV10N0713TR Applications
There are a lot of STMicroelectronics VNV10N0713TR Power Switches ICs applications.
- USB Protection
- Wireless/Networking Cards
- Low Voltage I/O System Power
- Hot Swap
- PC Cards
- Wearable Devices
- Set-top-box
- Wireless Headsets
- USB Power Distribution
- Handheld Devices