banner_page

VNV20N07-E

N-Channel PMIC OMNIFET?, VIPower? Series VNV20 10 Pin PowerSO-10 Exposed Bottom Pad


  • Manufacturer: STMicroelectronics
  • Nocochips NO: 761-VNV20N07-E
  • Package: PowerSO-10 Exposed Bottom Pad
  • Datasheet: PDF
  • Stock: 593
  • Description: N-Channel PMIC OMNIFET?, VIPower? Series VNV20 10 Pin PowerSO-10 Exposed Bottom Pad (Kg)

Details

Tags

Parameters
Factory Lead Time 1 Week
Lifecycle Status ACTIVE (Last Updated: 7 months ago)
Mount Surface Mount
Mounting Type Surface Mount
Package / Case PowerSO-10 Exposed Bottom Pad
Number of Pins 10
Packaging Tube
Series OMNIFET™, VIPower™
Part Status Active
Moisture Sensitivity Level (MSL) 3 (168 Hours)
ECCN Code EAR99
Resistance 50mOhm
Max Power Dissipation 83W
Base Part Number VNV20
Number of Outputs 1
Output Type N-Channel
Max Output Current 14A
Operating Supply Voltage 18V
Interface On/Off
Nominal Supply Current 250μA
Output Configuration Low Side
Power Dissipation 83W
Output Current 14A
Voltage - Supply (Vcc/Vdd) Not Required
Max Supply Current 250μA
Input Type Non-Inverting
Switch Type General Purpose
Continuous Drain Current (ID) 20A
Ratio - Input:Output 1:1
Voltage - Load 55V Max
Fault Protection Current Limiting (Fixed), Over Temperature, Over Voltage
Drain to Source Breakdown Voltage 70V
Rds On (Typ) 50m Ω (Max)
Drain to Source Resistance 50mOhm
Radiation Hardening No
RoHS Status ROHS3 Compliant

VNV20N07-E Overview


It is packaged in the manner of a Tube.In the PowerSO-10 Exposed Bottom Pad package, it is included.A Surface Mount mounting is used for the LED driving board.The switch type is General Purpose.The LED driver has a total of 1 outputs.To operate, it needs a supply voltage of Not Required.The maximum output voltage of this LED driver is N-Channel volts.The VNV20 family contains this object.The 10 pins are used for the operation of the system.Maximum output current falls to 14A when operation criteria are met.The LED driving board is mounted in the way of Surface Mount.Lighting drivers with 50mOhm resistance are used.It belongs to the OMNIFET?, VIPower? series.The output current is set to 14A in this case.It is recommended to set the supply voltage to 18V for optimum efficiency.250μA is the maximum current required to operate it.

VNV20N07-E Features


Resistance of 50mOhm

VNV20N07-E Applications


There are a lot of STMicroelectronics VNV20N07-E Power Switches ICs applications.

  • Portable GPS Device
  • PC Cards
  • USB Power Distribution
  • PDAs
  • Smart Phones, Feature Phones
  • USB Protection
  • Hot Swaps
  • Hot Swap
  • Wireless Headsets
  • USB Ports/Hubs

Write a review

Note: HTML is not translated!
    Bad           Good