VNV35N07-E
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Lifecycle Status | ACTIVE (Last Updated: 8 months ago) |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | PowerSO-10 Exposed Bottom Pad |
| Number of Pins | 10 |
| Packaging | Tube |
| Series | OMNIFET™, VIPower™ |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 3 (168 Hours) |
| ECCN Code | EAR99 |
| Resistance | 28mOhm |
| Max Power Dissipation | 125W |
| Base Part Number | VNV35 |
| Number of Outputs | 1 |
| Output Type | N-Channel |
| Max Output Current | 35A |
| Operating Supply Voltage | 18V |
| Interface | On/Off |
| Nominal Supply Current | 250μA |
| Output Configuration | Low Side |
| Power Dissipation | 125W |
| Output Current | 25A |
| Voltage - Supply (Vcc/Vdd) | Not Required |
| Max Supply Current | 250μA |
| Input Type | Non-Inverting |
| Switch Type | General Purpose |
| Continuous Drain Current (ID) | 35A |
| Ratio - Input:Output | 1:1 |
| Voltage - Load | 55V Max |
| Fault Protection | Current Limiting (Fixed), Over Temperature, Over Voltage |
| Drain to Source Breakdown Voltage | 70V |
| Rds On (Typ) | 28m Ω (Max) |
| Drain to Source Resistance | 28mOhm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
VNV35N07-E Overview
It is packaged in the manner of a Tube.This package is included in PowerSO-10 Exposed Bottom Pad.The LED driver is mounted as Surface Mount.The switch type is General Purpose.The LED driver has 1 outputs.In order to operate, it requires a voltage supply of Not Required.There is a maximum output voltage of N-Channel volts on this LED driver.As you can see, it comes from the VNV35 family.In order to operate, the 10 pins are used.This operation requires the maximum output current to be decreased to 35A.As a result, it is mounted in the manner of Surface Mount.In this LED driving board, there is 28mOhm resistance.The OMNIFET?, VIPower? series includes this electrical component.This case results in a 25A output current.The supply voltage should be set at 18V for best efficiency.It requires 250μA current to operate.
VNV35N07-E Features
Resistance of 28mOhm
VNV35N07-E Applications
There are a lot of STMicroelectronics VNV35N07-E Power Switches ICs applications.
- Various applications equipped with buttons
- HDD and SSD
- Hard Disk Drives
- Set-top-box
- Notebook PC
- USB Power Distribution
- Set-Top Boxes
- Storage (HDDs, SSDs)
- USB Protection
- Smart Phones, Feature Phones
