VNV35N07TR-E
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Lifecycle Status | ACTIVE (Last Updated: 6 months ago) |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | PowerSO-10 Exposed Bottom Pad |
| Number of Pins | 10 |
| Packaging | Tape & Reel (TR) |
| Series | OMNIFET™, VIPower™ |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 3 (168 Hours) |
| Resistance | 28mOhm |
| Max Power Dissipation | 125W |
| Base Part Number | VNV35 |
| Number of Outputs | 1 |
| Output Type | N-Channel |
| Max Output Current | 35A |
| Operating Supply Voltage | 18V |
| Interface | On/Off |
| Nominal Supply Current | 250μA |
| Output Configuration | Low Side |
| Power Dissipation | 125W |
| Output Current | 25A |
| Voltage - Supply (Vcc/Vdd) | Not Required |
| Max Supply Current | 250μA |
| Input Type | Non-Inverting |
| Switch Type | General Purpose |
| Ratio - Input:Output | 1:1 |
| Voltage - Load | 55V Max |
| Fault Protection | Current Limiting (Fixed), Over Temperature, Over Voltage |
| Rds On (Typ) | 28m Ω (Max) |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
VNV35N07TR-E Overview
It is packaged in the form of a Tape & Reel (TR).There is a package for it in the PowerSO-10 Exposed Bottom Pad package.Mounting type Surface Mount is selected for the LED driving board.It owns the General Purpose switch type.The lighting driver is equipped with 1 outputs that can be used.A supply voltage of Not Required is required for it to operate.A maximum voltage of N-Channel volts is available from the output of this LED driver.There is a VNV35 family of things that it belongs to.The operation is carried out using the 10 pins.The maximum output current is reduced to 35A to meet the operation criteria.Surface Mount is mounted in the way of this LED driving board.Currently, the LED driving board has 28mOhm resistance.This electrical component is included in the OMNIFET?, VIPower? series.It is set to 25A in this case.In order to optimize the efficiency of the supply voltage, it should be set to 18V.For its operation, a maximum current requirement of 250μA is required.
VNV35N07TR-E Features
Resistance of 28mOhm
VNV35N07TR-E Applications
There are a lot of STMicroelectronics VNV35N07TR-E Power Switches ICs applications.
- USB Power Distribution
- HDD, SSD
- Hot Swap
- Set-top-box
- Portable Devices
- USB Ports/Hubs
- Wireless/Networking Cards
- PC Cards
- Hot-Swap Systems
- Hot Swaps
